Single-phase D-STATCOM prototype based on the use of an Arduino nano controller.

Authors

  • Triana Figueroa, Mauricio José
  • Diaz Rodriguez, Jorge Luis
  • Pardo Garcia, Aldo

DOI:

https://doi.org/10.18687/LACCEI2023.1.1.1031

Keywords:

Prototyping, power electronics, FACTS, D-STATCOM, Arduino nano.

Abstract

This paper deals with the design, tests, and results obtained by implementing a D-STATCOM prototype. The process is detailed from the point of view of the design, going to the operation of the D-STATCOM and ending with the design of the prototype. Finally, an analysis of the tests and results obtained is carried out to validate the design and the developed prototype.

Downloads

Published

2023-07-27

Issue

Vol. 1 No. 8 (2023): LACCEI 2023

Section

Articles

Copyright

Copyright (c) 2023 LACCEI

View LACCEI official copyright policy

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

LACCEI retains copyright of all published articles under the terms of its copyright transfer agreement. As the copyright holder, LACCEI distributes the articles to the public under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License (CC BY-NC-SA 4.0).

How to Cite

Triana Figueroa, Mauricio José, Diaz Rodriguez, Jorge Luis, & Pardo Garcia, Aldo. (2023). Single-phase D-STATCOM prototype based on the use of an Arduino nano controller. LACCEI, 1(8). https://doi.org/10.18687/LACCEI2023.1.1.1031